RUST-OLEUM 2190 MATT WHITE AEROSOL 500ML

RU THH2190
RUST-OLEUM 2190 MATT WHITE AEROSOL 500ML

RUST-OLEUM 2190 MATT WHITE AEROSOL 500ML

06-0700012

RRP: £10.19

£8.40 (+ VAT)

Product Options

- +

 

Add to Cart

 

Rust-oleum Matt White

RUST-OLEUM® Hard Hat Aerosol Topcoats 2100 are based on a fast drying short oil soya alkyd. The products are based on lead- and chromate free pigments.

RECOMMENDED USES 

  • RUST-OLEUM Topcoats 2100 should be applied over RUST-OLEUM Hard Hat 2169/2182 Primers or properly prepared painted substrates.
  • RUST-OLEUM Topcoats 2100 are intended for small maintenance jobs or for touch-up.
  • RUST-OLEUM Topcoats 2100 should be used in light industrial exposures, normal humidity and interior applications

 

Technical Data

  • Appearance: High gloss, 2190 and 2178 are flat
  • Propellant: Dimethyl ether
  • Recommended film thickness: 25 ìm dry, equals averagely 100 ìm wet
  • VOC-content: 640 - 650 g/l

Drying times 20°C/50% r.v.

  • To touch: 15 minutes
  • To handle: 30 minutes
  • To recoat: Within 1 hour or after 48 hours
  • Full hardness 7 days
  • Heat resistance: 100°C (dry heat), above 65°C discoloration may occur

COVERAGE

  • Theoretical: 2.5 m² per spray can at 25 ìm dry
  • Practical: Practical coverage depends on many factors such as porosity androughness of the substrate and material losses during application.

SURFACE PREPARATION
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application.
DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
APPLICATION CONDITIONS
For good results the relative humidity shall be below 85% and the temperature of the can above and substrate 0°C.
REMARKS

Bright topcoats may need a light coloured primer/intermediate coat.

 

Close