RUST-OLEUM ZINC SPRAY

RU THH2185
RUST-OLEUM ZINC SPRAY

RUST-OLEUM ZINC SPRAY

06-0700004

RRP: £13.22

£12.16 (+ VAT)

Product Options

- +

 

Add to CartPlease select an option below

You must specify which product options you want before you can purchase this product

 

Rust-oleum Zinc Spray

RUST-OLEUM® Hard Hat Aerosol Zinc Spray Cold Galvanising Compound 2185 is a fast drying zinc rich primer based on an epoxy ester resin. The product contains pure zinc as pigment and provides cathodic protection.

RECOMMENDED USES

  • RUST-OLEUM Zinc Spray 2185 should be used on new, bare steel or galvanised steel surfaces.
  • RUST-OLEUM Zinc Spray 2185 is intended to be applied on small areas or for touch-up.
  • RUST-OLEUM Zinc Spray 2185 can be recoated with non-saponifiable coatings.
  • RUST-OLEUM Zinc Spray 2185 should be used as a primer or as a single coat in light industrial exposures, corrosive environments and high humidity areas.

TECHNICAL DATA

  • Appearance: Flat
  • Colour: Grey
  • Propellant: Dimethyl ether
  • Recommended film thickness: 35 ìm dry, equals 100 ìm wet
  • VOC-content: 630 g/l
  • DIN 50.976 : 90% Zinc

Drying times 20°C/50% r.v.

  • To touch: 10 minutes
  • To handle: 30 minutes
  • To recoat: Within 1 hour or after 48 hours
  • Full hardness 7 days
  • Heat resistance: 450°C (dry heat)

Coverage

  • Theoretical: 1.4 m² per spray can at 35 ìm dry
  • Practical: Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.

SURFACE PREPARATION
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. The surface must be clean and dry during application.

DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply a full, wet coat to achieve a close, dense coating film,
avoid dry spray. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.

APPLICATION CONDITIONS
For good results the relative humidity shall be below 85% and the temperature of the can and substrate above 0°C.

SAFETY
Consult Safety Data Sheet and Safety Information printed on the can.

Close