RUST-OLEUM BRIGHT GALV PRIMER

RUST-OLEUM BRIGHT GALV PRIMER

06-0700005

RRP: £12.99

£12.16 (+ VAT)

Product Options

- +

 

Add to CartPlease select an option below

You must specify which product options you want before you can purchase this product

 

Rust-oleum Hard Hat Bright Galv Primer

RUST-OLEUM® Hard Hat Aerosols Zinc Aluminium Spray Bright Galvanising 2117 is a fast drying zinc rich primer/topcoat based on an epoxy ester resin. The product contains pure zinc and aluminium as pigment and provides cathodic protection.


Recommended Uses

  • RUST-OLEUM Zinc Aluminium Spray 2117 should be used on damaged galvanised steel surfaces.
  • RUST-OLEUM Zinc Aluminium Spray 2117 is intended to be applied on small areas or for touch-up.
  • RUST-OLEUM Zinc Aluminium Spray 2117 should be used as a single coat in light industrial exposures, corrosive environments and high humidity areas.

TECHNICAL DATA

  • Appearance: Flat
  • Colour: Aluminium
  • Propellant: Dimethyl ether
  • Recommended film thickness:  35 μm dry, equals 115 μm wet
  • VOC-content: 647 g/l

Drying times 20°C/50% r.v. 

  • To touch: 20 minutes
  • To handle: 60 minutes
  • To recoat: Within 2 hours or after 48 hours
  • Full hardness 7 days
  • Heat resistance: 450°C (dry heat)

Coverage

  • Theoretical:   1.2 m² per spay can at 35 μm dry
  • Practical:  Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.

SURFACE PREPARATION
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. The surface must be clean and dry during application.
DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply a full, wet coat to achieve a close, dense coating film, avoid dry spray. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
APPLICATION CONDITIONS
For good results the relative humidity shall be below 85% and the temperature of the can and substrate above 0°C.
REMARKS
Both products are lead- and chromate free thus eliminating the danger of poisonous gases escaping if the coated surface needs to be welded at a later date.

   

Close